Yiazo YBF Setup Guide
Contents:
0a) What to Expect?
0b) What You Need
1) Powering
2) Cooling
3) Configuration
4) Troubleshooting
5) Where to buy
0a) What to Expect?
0b) What You Need
1) Powering
2) Cooling
3) Configuration
4) Troubleshooting
5) Where to buy
0) What to Expect?
The Yiazo YBF is a Bitfury generation 2 clone designed by c-scape which utilises the known M and H board architecture. Each mining kit includes one M board and multiple hashing H boards. The boards come snugly packaged in bubble wrap within a cardboard box. Specs per H board are as follows:
The Yiazo YBF is a Bitfury generation 2 clone designed by c-scape which utilises the known M and H board architecture. Each mining kit includes one M board and multiple hashing H boards. The boards come snugly packaged in bubble wrap within a cardboard box. Specs per H board are as follows:
|
Chips
Hashrate Rated Voltage Rated Current Power Consumption |
-14x Bitfury Gen 2
-~30-38GH -12V -1.6A -20W |
|
|
1) Powering
YBFs do not come with a power supply, and you will need a typical computer PSU with:
YBFs do not come with a power supply, and you will need a typical computer PSU with:
- 2xPCI-E 6 pin power connectors (only 1 if using 4 or less H boards.
- 2A on the 12V rail per H board.
|
Power Supply:
(Click your flag) |
|
|
|
|
We also need to tell the PSU to always be on, as there isn't a motherboard to do this. Cut a paperclip into a U and insert it into the green wire and either black wire to the side of the green wire. Tape it up for safety. The power supply will now be controlled by its switch on the rear socket.
|
|
2) Cooling
A 120mm fan is required to blow through the H boards, and two when they are packed closely. They can be low RPM and silent, but airflow is required. Alternatively, one moderate to high (1600+) RPM 120mm fan can be placed on top of the H boards. There are 2x3 pin fan headers on the M board.
A 120mm fan is required to blow through the H boards, and two when they are packed closely. They can be low RPM and silent, but airflow is required. Alternatively, one moderate to high (1600+) RPM 120mm fan can be placed on top of the H boards. There are 2x3 pin fan headers on the M board.
|
120mm Fans:
|
|
|
|
|
|
|
|
|
3) Configuration
YBFs contain their own controller and so setup is self sufficient.
YBFs contain their own controller and so setup is self sufficient.
- Connect the ethernet cable from the M board to your router.
- Using a browser, navigate to your router's configuration page to find the IP assigned to the YBF. It will be listed under 'miner-0'.
- Using a browser, navigate to this IP address..
- Enter pool information as below, and click "Reset".
- After a few seconds, press "Reset" to check mining has started.
mint.bitminter.com with port 3333
us1.ghash.io with port 3333
stratum.mining.eligius.st with port 3334
|
|
4) Troubleshooting
|
Problem
TBD as problems arise. |
Solution
|
|
|
Disclaimer: No warranty is provided with this information. It is your own responsibility if you or your property are injured or damaged following the information.
5) Where to buy
|
|
|